FixYourDLP.com Forums

DB Aperture 'closed' setting does not seem to save when i exit the service menu? I use the mute - 1 - 8 - 2 - power to get into the menu and use the steps below (found on forum), and then exit by hitting menu until back to main screen then I hit power. When I power the set back on the change did not stick? I must be missing something that functions a save sommand, but don't know what it is.

***Under the “SP Actuator” section of the service menu, turn “DB On/Off” to Off. Then in the same section of menu, scroll down to the now available “DB Aperture” setting. Set this to “Close.”***

Any advice/help is appreciated!