Page 1 of 1
Help Please
Posted: Tue Aug 17, 2010 12:11 am
by gsauls01
Just replaced the ballast and it still does not work. The light flickers and the little capacitor flickers. What is my next option?
Re: Help Please
Posted: Tue Aug 17, 2010 4:44 pm
by darkart77
Make sure that the lamp is placed correctly in the tv along with the housing, there are a couple of positioning sensors, so...push the housing a bit further and the panel that you open has to be closed all the way in before turning tv back on.
Re: Help Please
Posted: Wed Aug 18, 2010 8:21 pm
by johnrot
Hi gsauls01
Im concerned when you say " little capacitor flickers" what do you mean by that? :ugeek:
Re: Help Please
Posted: Thu Aug 19, 2010 1:32 am
by gsauls01
On the Ballast module; their is a little "looks like a capacitor" that is trying to light up
Re: Help Please
Posted: Thu Aug 19, 2010 1:34 am
by gsauls01
I pushed the bulb in as far as it will go and closed the clamp on it. You mean put the back panel on before check ing the TV?
Re: Help Please
Posted: Thu Aug 19, 2010 2:27 pm
by darkart77
Yes the back panel; along with any other panels will have to be closed all the way in. Other wise the tv, will not turn on. Safety mechanism.
Re: Help Please
Posted: Thu Aug 19, 2010 9:47 pm
by johnrot
Hi
The lamp it has gas on the inside so the funtion of the ballast is to send an electric arc so the electricity ignites the gas in the lamp (like the fluorescent kitchen lamps), so when you see an electric arc outside of the lamp in this case on the ballast itself it means that the ballast is not working properly, hope this information can help you :ugeek: