Page 1 of 1
Samsung DLP - HDMI input works, but not other AV
Posted: Sat Jun 04, 2011 10:26 pm
by sabatorious
Recently acquired a 50' Samsung DLP (HLR5067wax/xaa) which distorts inputs other than HDMI (AV1, 2, 3, etc.). I have attached a picture below. Any suggestions would be much appreciated, as I would rather be certain what the problem is before I spend $$$ on costly parts in vain. Thanks.
Re: Samsung DLP - HDMI input works, but not other AV
Posted: Mon Jun 06, 2011 9:43 pm
by grayfox
hhmmm so the Digital HDMI signal if fine??? and the other analog inputs are like this???
This is almost certainly the Digital Video Board, its easy to replace and relatively inexpensive! (discount-merchant.com has them for around $40)
The problem lies when DLP technology projects Digital signal, if a signal is already digital then it goes straight to the DMD board for projecting, but if it is an Analog input it need to be "digitalized" and run through a Digital Video Board before it is sent to the DMD board for projecting, that is where i think your problem lies...
hope this helps... :mrgreen:
Re: Samsung DLP - HDMI input works, but not other AV
Posted: Sun Jun 12, 2011 3:16 am
by sabatorious
Thanks, grayfox. That saves me from unnecessarily replacing the analog board if the solution is as you describe ... Will post update when I replace. Another question for you: While using HDMI, every half hour (can be longer or shorter) or so, the signal will drop and it acts like it the HDMI cable disconnects. It doesn't matter the source (computer, dvd, etc), it just goes black or green, but does not completely turn the TV off. I thought maybe it could be a lamp problem, but it seems to stay on, just loses the HDMI signal, reconnects, and is back in business within about three to four seconds or so. Any thoughts!? Thanks!!!
Re: Samsung DLP - HDMI input works, but not other AV
Posted: Mon Jun 13, 2011 9:16 pm
by grayfox
well if it heats up enough and it is already malfunctioning it can get to that point... it looks like its in a place where it gets adequate ventilation... how long has it been since you replaced the lamp?
Re: Samsung DLP - HDMI input works, but not other AV
Posted: Mon Jun 13, 2011 9:16 pm
by grayfox
btw a lamp cannot cause this kind of distortion but it can blank out if it is weak ;)
Re: Samsung DLP - HDMI input works, but not other AV
Posted: Tue Jun 14, 2011 4:34 pm
by sabatorious
Hmm. The lamp has not ever been replaced - I assumed it couldn't be the lamp since the unit did not completely shut off and take time to cool down, but maybe the lamp is the shut off problem. Thanks for your feedback!
Re: Samsung DLP - HDMI input works, but not other AV
Posted: Tue Jun 14, 2011 5:36 pm
by grayfox
Welcome!
I hope its clear that the lamp only emits white light, so you are correct the only hand it can have in your problem is the shutdown, the actual distortion on screen is caused by what we spoke, however it is around time you change the lamp! either way its bound to go out at any time! :(