Internal Board-to-Board Cabling/Connectors

[jjselle]

*This is NOT a request for color wheel, bulb, or ballast replacement instructions*

I have replaced my BP96-00674A color wheel, but in the process severed the 5-pin cabling from the PCB (there are 3 *unmarked* connectors in a row on the top right of the PCB - this is rightmost one). The connector is still in the receptacle on the PCB but is badly mangled from my "tweezing* it out. The wire is still in good shape, though separated from the connector.

My questions are these:

Can this cable/connector be replaced or repaired/soldered?

If so, where can I find resources to replace or repair?

Thanks in advance.

[Eddie]

If you have enough of the wire, I'd tie em and heat shrink em. If they are too small, just a small solder might work, then tape electrical tape around it..