This guide is being published to show how easy it is to replace your original RCA 270414 Lamp.
Click below to buy this lamp now:
Lowest Prices Anywhere!
NORMAL DISCLAIMER:
— Do NOT purchase generic brand lamps such as LTI, APO or third-party manufacturers such as OSRAM. These lamps were NOT engineered with and for your TV…only your Philips lamp has been engineered to work flawlessly and output the best possible color. Above that, it just doesn’t make sense to choose an aftermarket lamp for a $5-$10 difference (and in many cases they are more expensive!!). Be a smart consumer and do your research! Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!
Necessities:
1. A Torx T9 screwdriver
2.
A PHILIPS screwdriver
2. A Pair of Pliers
3. A new Philips Lamp
4. 15 minutes of your time
NOTE: The bulb should be handled with a clean lint-free cloth at all times to avoid any dirt or oil. Our hands are naturally oily…The oil residue from our hands can cause premature failure of the lamp if the front side of the lamp is not wiped down after the installation. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lent free cloth before reinstalling your lamp…
Here is the RCA Lamp Enclosure, remember you can click on any image to enlarge!
Step 1: We start by unscrewing the connector wiring… First we remove the nut and then the screw (or vise versa)...
Now we need to remove the two T9 Torx screws holding the lamp cradle to the housing... This makes it easier to take apart the lamp...
Now we remove the T9 Torx screws to remove the vent filters and release the lamp..
Now we pull the lamp out and reverse the steps to put the new lamp back in...
Remember not to mix up the good bulb and the bad bulb... Sometimes it is very hard to tell the difference between a bad lamp and a good lamp. If you get mixed up you will have to physically try both lamps in your TV.
***Technicians: Don't bother checking for CONTINUITY becuase ALL UHP LAMPS WILL FAIL CONTINUITY TESTS as the lamps have a "firing gap" in the filament (similar to a car's spark plug).
We start by puting in the new lamp and re-installing the vent filters...
We now re-connect the lamp terminals to the connector wire...
NOTE: Be careful when screwing-in the side connector on to your new lamp. It’s best to hand torque as this terminal is very sensitive and might break with a lot of torque.
Let's re-assemble the enclosure by putting the two T9 Torx screws back in and get ready to watch some TV!
Whallah! Your all done…10-15 mins MAX!
IMPORTANT: The bulb should be handled with a clean cloth at all times to avoid any dirt or oil. Our hands are naturally oily…this is a no-no for these lamps. It doesn’t hurt to do a final wipe with a clean, non-abrasive, lent free cloth before reinstalling your lamp…
Again, Discount-Merchant.com promises to be the low price leader in all Projection TV Lamps they carry…if this is not true, let us know and we’ll fix it!
Click below to buy this lamp now:
Lowest Prices Anywhere!